EVGA 122-YW-E173 manual Pin ATX 12V Power PWR2, Connecting IDE Hard Disk Drives

8-pin ATX 12V Power (PWR2)

PWR2, the 8-pin ATX 12V power connection, is used to provide power to the CPU. Align the pins to the connector and press firmly until seated. This connector is notched, do not force in.

1 GND4

5 12V 8

Connecting IDE Hard Disk Drives

Card Edge

IDE Connector

The IDE connector supports Ultra ATA 133/100/66 IDE hard disk drives.

1.Connect the blue connector (the cable end with a single connector) to the motherboard.

2.Connect the black connector (the cable with the two closely spaced black and gray connectors) to the Ultra ATA master device.

3.Connect the gray connector to a slave device.

If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk drive’s documentation for the jumper settings.

If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive.

EVGA 14