Bracket | Evo Fitness 50551 guide

assembly instructions

ASSEMBLY

Step 8:

Insert two 1" Plastic Bushings (60) into the holes in the Top Frame (7).

Attach the Lat Bar Holder (14) to the Top Frame (7) using two 3/8" x 3" Hex Head Bolts (74), four 3/8" Washers (90) and two 3/8" Nylon Nuts (94).

Place the Top Frame (7) over the Guide Rods (22) and insert the Guide Rods into the holes in the Top Frame

(7). Align the mounting holes in the "L" bracket (welded on the Top Frame (7)) with the holes in the Upright (3) then attach with two 1/2" x 4-1/4" Hex Head Bolts (70), two 1/2" x 3" Hex Head Bolts (72), eight 1/2" Washers (89) and four 1/2" Nylon Nuts (93).

L-BRACKET

-14-

Image 14

Evo Fitness 50551 owner manual Bracket

Contents

EVO Sedona Home Gym Preassembly Before Beginning Parts list Majority of the Listed Hardware is Already in Place Place Majority of the Listed Hardware is Already ADJ Cable Small Pulley Parts diagram By the Factory Assembly Instructions Assembly instructions Step Assembly Assembly instructions Detail TOP View Assembly instructions Bracket Assembly instructions Firmly tighten all fasteners at this time TOP Cable TOP Cable Path FIG-C2,C6 Connect Cable Path FIG-C1,C7FIG-C3 FIG-C4,C5 FIG-P1,P8 FIG-P3 FIG-P4 FIG-P5,P6 PEC DEC CablePEC DEC Cable Path Lower Cable Routing the Lower Cable Assembly instructions Assembly instructions Page Warranty Warranty Important steps Important Steps Exercising Target heart rateYour Target Zone Muscle chart Muscle Chart Warm UP Stretching routineCool Down Shoulder Lift Page