Firmly tighten all fasteners at this time

assembly instructions

ASSEMBLY

Step 10:

Attach the Pec Dec Support (16) to the Pec Dec Base (6) using two 1/2" x 3-1/8" Hex Head Bolts (71), four 1/2" Washers (89) and two 1/2"

Nylon Nuts (93).

Insert the axle of the Right Pec Dec Arm (10) into the sleeve on the Pec Dec Support (16) then attach with one 1/2" Nylon Nut (93) and one 1/2" x 1-1/4" Washer (88). Cap the 1/2" Nylon Nut (93) with one Cap For Nut (55).

Cap the Right Pec Dec Arm (10) with one 2" Round End Plug (51). Slide the Rubber Ringlet (68) onto the Right Pec Dec Arm (10). Attach one Elbow Pad (32) to the Right Pec Dec Arm (10) using two 3/8" x 1"

Hex Head Bolts (81) and two 3/8" Washers (90).

Repeat the same procedure for attaching the Left Pec Dec Arm (11) to the Pec Dec Support (16).