instructions | ASSEMBLY |
assembly |
|
Step 9:
Cap the Leg Curl (19) with two 2" Sq End
Plugs (43). Insert two 1/2" Steel Bushings
(52)into the hole in the Leg Curl (19). Attach the Leg Curl (19) to the Seat Support (18) using the 1/2" Axle (61), two 5/16" x 5/8" Sunken Head Screws (79), two 5/16" Spring Washers (80) and two 5/16" Washers (81). Insert the Bolster
(12)into the hole in the Leg Curl (19) and secure with the 5/16” x 1/2” Sunken Head Bolt (68). Slide one 4" Foam Pad (27) onto each end of the Bolster (12) then cap both ends of the Bolster (12) with a 1" End Plug
(44)as shown in FIG 15. If the Foam Pads (27) are difficult to slide onto the Bolster (12) try applying a small amount of soapy water to the Bolster (12) prior to sliding on the pads.
|
