
ASSEMBLY
Step 10:
Cap the Adj Seat Arm (20) with two 2" Sq End Plugs (43). Slide the 1" Hand Grips (30) onto the Seat Handle Bars (21). Attach the Seat Handle Bars (21) to the Adj Seat Arm (20) using two 3/8" x 3" Hex Head Bolts (65), four 3/8"
Washers (75) and two 3/8" Nylon Nuts (77). Attach the Seat Pad (25) to the Adj Seat Arm (20) using two 3/8" x 2- 1/2" Hex Head Bolts (70) and two 3/8" Washers (75) as shown in FIG 16.
Insert the Adj Seat Arm (20) into the Seat Support (18) and lock with the Quick Release (55). Insert the Bolster
(12)into the sleeve (welded on the Adj Seat Arm) and secure with a 5/16" Sunken Head Screw (78). Slide a 4" Foam Pad (27) onto each end of the Bolster (12) as shown in FIG 17. If the Foam Pads (27) are difficult to slide onto the Bolster (12) try applying a small amount of soapy water to the Bolster
(12)prior to sliding on the pads. Cap each end of the Bolster (12) with a 1" End Plug (44).
Firmly tighten all bolts at this time.
assemblyinstructions |