5.If necessary, remove one of the floppy disk drives to provide an empty
CAUTION
If you remove floppy disk drive B to install the tape drive, be sure to change your system configuration to reflect this. Refer to your computer owner’s manual for details on running the system’s setup program.
Mounting Procedure
Follow these steps to mount the tape drive:
1.Check for the presence of a load resistor in the computer. If it is present, disconnect the load resistor cable from the power supply. Refer to your computer owner’s manual for more information.
2.Use #6 32 screws to attach two slide rails to the sides of the tape drive (see Figure 6). The tapered end of each rail should point toward the rear of the tape drive.
Figure 6 Attaching the slide rails to the tape drive
18 | 306261 |
