Exabyte EXB-8500 manual Loading a Data Cartridge, Unloading a Data Cartridge, Unload Button

Loading a Data Cartridge

To load a data cartridge into the tape drive, follow these steps:

1.Ensure that the write-protect switch has been set correctly for the desired operation, as explained on page 26.

2.If you have just powered on the tape drive, be sure that the green LED is off, indicating that the tape drive has passed its power-on self-test and is ready to load the data cartridge.

3.If necessary, press the unload button to open the door on the tape drive.

4.Insert the data cartridge into the tape drive with the label side up and the write-protect switch facing you.

5.Gently close the door. The tape drive automatically loads the data cartridge and indicates ready status (green LED on).

Note: Most tape drives load the data cartridge automatically. However, your application software may disable the autoload function. If the data cartridge does not go to the ready state after you close the door, consult your software documentation for information.

Unloading a Data Cartridge

Unload Button

The unload button is the only operator control on the tape drive. It is used to unload the tape from the tape drive.

The unload button can also be used to clear servo and other errors. If a servo or hardware error occurs, press the unload button to reset the tape drive. Then, if necessary,

December 1993 EXB-8500/EXB-8500c 27