Exmark 0 Check Hydraulic Oil Level, Lubricate Grease Fittings, Check Tire Pressures, Maintenance

Maintenance

Check Hydraulic Oil Level

Service Interval: Before each use or daily

1.Stop engine and wait for all moving parts to stop. Engage parking brake.

2.Wait until the unit cools before checking the hydraulic oil.

3.Check expansion tank and if necessary add Exmark Premium Hydro Oil to the FULL COLD line (see Figure 22).

Lubricate Grease Fittings

Note: See chart for service intervals.

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2.Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose gun grease.

Refer to the following chart for fitting locations and lubrication schedule.

Lubrication Chart

Fitting			Initial	Number of		Service
Locations		Pumps		Places	Interval
1. Deck and	1			2	50 hours
Pump Idler
Pivots

Figure 22

1. Engine 2. Expansion tank

Check Tire Pressures

Service Interval: Every 50 hours

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2.Check tire pressure in drive tires.

3.Inflate drive tires to 13 psi (90 kPa).

4.Check tire pressure in caster tires.

5.Inflate caster tires to 13 psi (90 kPa).

Lubricate Caster Wheel Hubs

Service Interval: As required

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

Check Condition Of Belts

Service Interval: Every 50 hours

1.	Stop engine, wait for all moving parts to stop, and
	remove key. Engage parking brake.
2.	Remove left and right belt shields on deck and
	lower the deck to inspect deck drive belt.
3.	Check under machine to inspect the pump drive	Figure 23

belt.

Note: No adjustments are required for belt tension.

1. Seal guard	2. Spacer nut with wrench
	flats

32