Maintenance
Figure 32
1. Brake mounting bolt | 2. Shim |
B.Using needle nose pliers, or by hand, take hold of the tab and remove the shim (Do Not discard the shim until proper clutch function has been confirmed).
C.Using a pneumatic line, blow out any debris from under the brake pole and around the brake spacers.
D.
E.Using a 0.010 inch thick feeler gauge, verify that a gap is present between the rotor and armature face on both sides of the brake pole as shown. (Due to the way the rotor and armature faces wear (peaks and valleys) it is sometimes difficult to measure the true gap.)
Figure 34
1.Feeler gauge
•If the gap is less than 0.010 inch, then reinstall the shim and reference the Troubleshooting section.
•If the gap is sufficient, proceed to the safety check in step F.
F.Perform the following safety check:
a.Sit on the seat and start the engine.
b.Make sure the blades Do Not engage with the PTO switch “off ” and the clutch disengaged.
If the clutch does not disengage, reinstall the shim and reference the Troubleshooting section.
c.Engage and disengage the PTO switch ten consecutive times to ensure the clutch is functioning properly. If the clutch does not engage properly, reference the Troubleshooting section.
1
Figure 33
1.Feeler gauge
G011733 | Motion Control Linkage |
| |
| Adjustment |
| Located on either side of the fuel tank, below the seat |
| are the pump control linkages. Rotating the pump |
| linkage with a 1/2 inch wrench allows fine tuning |
| adjustments so that the machine does not move in |
| neutral. Any adjustments should be made for neutral |
| positioning only. |
43
