Exmark S/N 790, 000 & higher, 4500-471 manual Transporting a Unit, Operation

Operation

Figure 17

For cutting heights above 3.5 inches (90 mm) use the bottom hole. The rollers will still be effective against scalping.

1. Anti-scalp roller	2. Cutting height
mounting bracket

For Maximum Deck Flotation, place the rollers one hole position lower. Rollers should maintain 1/4 inch (6.4 mm) clearance to the ground. Do Not adjust the rollers to support the deck.

7.Be sure the roller bolts are installed with the spring disc washer between the head of the bolt and the mounting bracket (Figure 18).

8.Torque the 3/8–24 x 2 Gr 8 hex capscrew to 50–55 ft-lb (68–75 N-m) (Figure 18).

Figure 18

1.	Spring disc washer	3.	3/8 nyloc-torque to 30-35
	(cone towards bolt head)		ft-lb (41-47 N-m)
2.	Front right anti-scalp	4.	3/8-24 x 2 GR8 torque to
	bracket shown		50-55 ft-lb (68-75 N-m)

Transporting

Transporting a Unit

Use a heavy-duty trailer or truck to transport the machine. Lock brake and block wheels. Securely fasten the machine to the trailer or truck with straps, chains, cable, or ropes. Be sure that the trailer or truck has all necessary lighting and marking as required by law. Secure a trailer with a safety chain.

CAUTION

This unit does not have proper turn signals, lights, reflective markings, or a slow moving vehicle emblem. Driving on a street or roadway without such equipment is dangerous and can lead to accidents causing personal injury. Driving on a street or roadway without such equipment may also be a violation of State laws and the operator may be subject to traffic tickets and/or fines.

Do Not drive a unit on a public street or roadway.

26