Maintenance
Figure 28
1.Single point height adjustment bolt
2.Front
3.Rear
15.To adjust the single point system, first loosen the front and rear
16.If the deck is too low, tighten the single point adjustment bolt by rotating it clockwise. If the deck is too high, loosen the single point adjustment bolt by rotating it counterclockwise.
Note: Loosen or tighten the single point adjustment bolt enough to move the
17.
Important: Torque the front and rear
18.Repeat steps 9 through 13.
Deck Removal
Before servicing or removing the deck, the spring loaded deck arms must be locked out.
WARNING
Deck lift arm assemblies have stored energy. Removing the deck with out releasing the stored energy can cause serious injury or death.
Do Not attempt to disassemble the deck from the front frame without locking out the stored energy.
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Remove the height adjustment pin and lower the deck to the ground.
3.Place the height adjustment pin in the 3 inch (7.6 cm) cutting height location. This locks the deck lift arms in the lowest position when the deck is removed.
4.Remove the floorpan and belt shields.
5.Insert 1/2 inch socket driver into the square hole on the idler bracket and carefully rotate the deck idler counterclockwise to remove the belt.
6.Remove and retain the hardware on both sides of the deck as shown in Figure 29.
Figure 29
1.Panhard rod (right side only)
2.Deck strut
3.Rear deck lift attachment shoulder bolt and nut.
4.Front deck lift attachment shoulder bolt and nut.
38
