Maintenance
Adjust RH Motion Control Handle Position
If the motion control levers do not align horizontally, adjust the right side motion control lever.
Note: Adjust the horizontal alignment before the front to back alignment.
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Push the right motion control lever down out of locked neutral position.
3.Check if it aligns horizontally with the left motion control lever.
Figure 34
1.LH Motion control lever
2.RH Motion control lever
3.RH Motion control lever in PTO disengaged position
4.Check the horizontal alignment here
4.To adjust the right motion control lever horizontally, the cam needs to be adjusted.
5.Release the cushion from the rear of the machine.
6.Loosen the nut and bolt holding the cam.
7.Adjust the cam until it aligns with the left motion control lever and tighten the nut and bolt for the cam.
Figure 35
1.Switch screws
2.Nut and bolt
3.Cam
4.Front reference/speed control handle
8.After the cam is adjusted, the lever switch needs to be checked.
9.Check the gap between the control lever and switch as shown in Figure 36. The gap needs to be an 1/8 inch (3mm) with the right motion control lever in the neutral, operate position.
Figure 36
1.Switch
2.Cam
3.Right motion control lever in the neutral operate position
4.1/8 inch (3mm)
10.If needed, loosen the screws holding the switch and adjust the switch.
11.Tighten the switch screws.
39
