Maintenance
Motion Control Neutral Lock Pivot Adjustment
The flanged nut can be adjusted to obtain a more desired motion control lever resistance (Figure 34).
Figure 34
1. Flanged nut | 2. Jam nut |
1.Loosen the jam nut.
2.Tighten or loosen the flanged nut to the desired feel.
For more resistance, tighten the flanged nut. For less resistance, loosen the flanged nut
3.Tighten jam nut.
Motion Control Handle Adjustment
Adjusting the height:
The motion control levers can be adjusted higher or lower for maximum operator comfort.
1.Remove the two bolts holding the control lever to the control arm shaft (Figure 35).
Figure 35
1. | Bolts | 4. | Nuts |
2. | Control lever | 5. | Slotted holes |
3.Control arm shaft
2.Move the control lever to the next set of holes. Secure the lever with the two bolts.
3.Repeat the adjustment for the opposite control lever.
Adjusting the Tilt
The motion control levers can be tilted fore or aft for maximum operator comfort.
1.Loosen the upper bolt holding the control lever to the control arm shaft.
2.Loosen the lower bolt just enough to pivot the control lever fore or aft Figure 35. Tighten both bolts to secure the control in the new position.
3.Repeat the adjustment for the opposite control lever.
Motion Control Full Forward Tracking Adjustment
If the machine travels or pulls to one side when the motion control levers are in the full forward position, adjust the cover plates.
1.Loosen the screws on a cover plate (see Figure 36).
2.Slide the cover plate backward or forward to adjust the travel of the lever and tighten the screws.
3.Drive the machine and check the full forward tracking.
4.Repeat steps 1 through 3 until desired tracking is obtained.
42
