Operation
5.Pull the starter handle lightly until you feel resistance, then pull it sharply. Allow the rope to return slowly.
6.For ECXHN21 Units: Gradually push in the choke control as the engine warms up.
Stopping the Engine
1.Bring the unit to a full stop.
•For units without a Blade Brake Clutch: Release the blade control bail. Both the engine and the blade should stop within three seconds.
•For units with a Blade Brake Clutch: Press the switch to “STOP” to kill the engine (see Figure 5).
Note: If the blade does not stop within 3 seconds after releasing the blade control bail, contact an Authorized Service Dealer.
2.Close the fuel
Note: The mower comes with freewheeling clutches which make it easier to pull the mower rearward. To disengage the clutches, you may need to push the mower forward one inch (2.5 cm) or more after you release the
Operating the Blade Control Bail (Units Without Blade Brake Clutch)
1.Squeeze the blade control bail against the handle.
2.Start the engine.
3.When the blade control bail is squeezed against the handle, the blade should engage.
4.Release the blade control bail. Both the engine and the blade should stop.
Operating the Blade Control Lever (Blade Brake Clutch Units Only)
1.Start the engine.
2.Push and hold the blade control lock lever forward to release the blade control bail (Figure 13).
Operating the
The lawn mower is variable speed, the more you squeeze the drive bail the faster the machine travels.
1.Start the engine.
2.Squeeze the drive bail against the handle (see Figure 4).
Note: You can vary the ground speed by increasing or decreasing the distance between the ground speed control bail and the handle. Lower the control bail to decrease the ground speed when you are making a turn or if the lawn mower is moving too fast for you. If you lower the control bail too far the lawn mower stops
3.To disengage the
Figure 13
1. | Blade control lock lever | 4. | Push forward |
2. | Locked position | 5. | Unlocked position |
3. | Blade control bail | 6. | Squeeze against handle |
3.Squeeze the blade control bail against the handle and release the blade control lock lever; the blade should engage.
4.Release the blade control bail to disengage the blade. The blade control lock lever will reset to lock the blade control bail.
Using the Mulch Plug
Occasionally you may wish to use the mulch plug to mulch the grass and leaf clippings back into the lawn.
•Installing the Mulch Plug:
1.Stop the engine and wait for all moving parts to stop.
17