Operation
Figure 17
1. | Front wheel shaft | 4. | Front quadrant block cut |
| assembly |
| heights |
2. | Pull up | 5. | Pull outward |
3. | Height adjuster | 6. | Shaft groove |
2.Insert the front wheel shaft assembly into the desired cut height setting in the front quadrant block. Lower the height adjuster into the groove on the front wheel shaft. Pull and push the wheel shaft assembly to make sure it has locked into place.
Using the Grass Bag
•Installing the Grass Bag
1.Stop the engine and wait for all moving parts to stop.
2.Open the rear door.
3.Grasp the handle on the bag and set the rear of the bag frame onto the handle bracket notch (Figure 18).
Figure 18
1. | Bag | 4. | Handle bracket notch |
2. | Handle | 5. | Rear door |
3. | Bag frame | 6. | Lower |
4.Once the bag is seated, lower the rear door onto the bag.
•Mowing with the Grass Bag
WARNING
A worn grass bag could allow small stones and other similar debris to be thrown in the operator’s or bystander’s direction. Thrown objects can result serious personal injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged, install a new Exmark replacement bag.
Cut the grass until the bag is full. Note: Do Not overfill the bag.
•Removing the Grass Bag
1.Stop the engine and wait for all moving parts to stop.
2.Raise the rear discharge door and grasp the handle on the bag.
3.Lift the bag off of the lawn mower and lower the rear discharge door.
4.Gradually tip the bag forward to empty the clippings.
5.To install the bag, refer to the section on Installing the Grass Bag.
20