Jura Capresso S90 Drawing off hot milk using the Auto-Cappuccinatore S9, Switching off machine

With the flow-adjustment you can set the optimum frothing. Turn the handle slightly to the right or to the left until you obtain the required result.

Fill water in a jug and immerse the intake-tube in the water. Now draw off steam until the water/steam mixture flowing into your cup is completely clean. Your Auto-Cappuccino is clean again.

11.3Drawing off hot milk using the Auto-Cappuccinatore S9

The Auto-Cappuccinatore of the S9 can be used to draw off hot milk. Adjust the selector lever (1) (Fig. 10) to position (3) to draw off hot milk.

Install the Auto-Cappuccino. This is included in your Welcome Pack.

11.4Drawing off cappuccino using the Auto-Cappuccintore S9

The Auto-Cappuccinatore of the S9 can be used to draw off capuc- cino. Adjust the selector lever (1) (Fig. 10) to position (2) to draw off capuccino.

11.5Controlling the temperature using the Auto-Cappuccinatore S9

Adjust the selector lever (1) to + for hot milk/cappuccino or - for less hot milk/cappuccino. Individual fine adjustment is possible.

11.6 Cleaning the Auto-Cappuccinatore

Remove Auto-Cappuccinatore (21). If you do not achieve optimum results, disassemble the flow controller and the selector lever (Fig. 10 for S9). Thoroughly rinse these parts with water.

As soon as you have frothed enough milk, it is important to clean the Auto-Cappuccino.

12. Switching off machine

When the machine is switched off, the rinsing program is auto- matically run again. Therefore place an empty container under the coffee-spout (15) and press ON/OFF key . When the rinsing water has run into the container, the machine powers down. Dis- card the water.

13. Programming

Before leaving our factory, the machine is adjusted to enable you to obtain coffee without any additional programming. In order to adapt the result to your personal taste, various settings can be pro- grammed individually. The programming keys are located behind the front cover (3).

The following settings can be programmed:

Powder quantity

Coffee temperature

Water quantity

Steam portion

Tea portion

Filter

Water hardness

Economy mode

Timer clock

Automatic switch on time

Automatic switch off time

Supplies and cup counter

Language selection

12