14.2 Empty grounds container
Coffee grounds are collected in the grounds container.
EMPTY GROUNDS
If this message shows on the display no more coffee can be drawn off. It is necessary to empty the grounds container.
Remove drip tray carefully as there is water in it.
Do not disconnect the machine from power socket while you empty grounds.
14.3 Empty drip tray
EMPTY TRAY
If this message shows on the display no more coffee can be drawn off. It is necessary to empty the drip tray.
Remove drip tray carefully as there is water in it.
Remove any remaining beans with a vacuum cleaner.
Put the spanner on (Fig.7).
Now turn spanner anticlockwise until the foreign object loosens.
Remove remaining powder with a vacuum cleaner.
Replace bean container and fasten screws.
14.6 Clean machine
CLEAN UNIT
After coffee, etc., has been drawn off 220 times or after 180 rinsing programs have been run, the machine must be cleaned. You can continue to draw off coffee and hot water / steam. However we recommend that you clean the machine (as described in chapter 14) within the next few days.
CLEAN NOW
An acoustic signal indicates the need of an immediate cleaning.
14.4 Fill beans
FILL BEANS
Fill beans as described in chapter 3.3.
The message FILL BEANS will only disappear after drawing off a coffee. We recommend cleaning the bean container from time to time with a dry cloth before you refill beans. Switch off the machine for this purpose.
14.7 Unit calcified
UNIT CALCED
The machine signals when decalcifying becomes necessary.
Under the correct implementation of Claris filter cartridges, decalcifying of the machine becomes unnecessary. For further indications read Chapter 7 “Use of Claris filter cart- ridges“.
14.5 Removing foreign objects
Switch off your machine by pressing ON/OFF key 
.
Remove plug from power socket.
Open bean container (13) and remove the beans. The remaining beans can be removed with a vacuum cleaner.
Loosen both screws in the bean container and then remove container (Fig.5 + 6)
14.8 Cleaning metal contacts
EMPTY TRAY / CLEAN CONTACTS
The remnants of the calcified deposits in the area of the metal contacts must be removed. Proceed as follows:
Rinse fastenings in groove (B) as well as the metal contacts (A) with hot water and some
16
