Maintenance
Important: Refer to your Engine Operator’s Manual for additional maintenance procedures.
Premaintenance
Procedures
Raising the Seat
Make sure the motion control levers are locked in the neutral position. Lift the seat forward until the lanyard is tight. The following components can be accessed by raising the seat:
•Auxiliary 12V Plug (12V accessory up to 15 amp)
•Fuses
•Battery cables
Accessing the Battery
The battery is located under the seat. To access, raise the seat (Figure 20).
Figure 20
1. | Auxiliary 12V Plug | 3. Seat |
2. | Battery |
|
|
|
|
Periodic Maintenance
Lubrication
Greasing the Bearings
Grease Type: NGLI grade #2
Grease the front caster pivots and wheels (Figure 21).
G007184
1
Figure 21
1.Front caster tire
1.Park the machine on a level surface and disengage the blade control switch.
2.Move the motion control levers outward to the neutral position, engage parking brake, stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position.
3.Clean the grease fittings (Figure 21 and Figure 22) with a rag. Make sure to scrape any paint off of the front of the fitting(s).
30
