![](/images/new-backgrounds/1115688/11568883x1.webp)
Maintenance
6.Route the new belt around the engine pulley and mower pulleys.
7.Pull the idler pulley in the direction shown in Figure 43 and route the belt onto the idler pulley.
8.Install the belt covers over the outside spindles.
Leveling the Mower Deck
The mower blades must be level from side to side. Check the
1.Park the machine on a level surface and disengage the blade control switch.
2.Move the motion control levers outward to the neutral position, engage parking brake, stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position.
3.Check the air pressure of all four tires. If needed, adjust to the recommended inflation; refer to Checking the Tire Pressure in Drive System Maintenance section. If either one is out of range then follow adjustment procedure.
4.Carefully rotate the blades side to side.
5.Measure between the outside cutting edges and the flat surface (Figure 44). If both measurements are not within 3/16 inch (5 mm), an adjustment is required; continue with this procedure.
7.Set
8.Set the
9.Carefully rotate the blades side to side (Figure 44).
10.Loosen the leveling adjust locking nuts (item 4) on all four corners so that the deck is sitting securely on all four blocks. Make sure that the deck hangers are all the way down (at the top of the slot) and the deck lift foot lever is pushed back against the stop, then tighten the four leveling adjust locking nuts
11.Recheck that blocks fit just snugly under the deck skirt. Make sure all attachment bolts are tight
12.Continue leveling the deck by checking the
Front-to-Rear Blade Slope.
13.Recheck blades for levelness and repeat deck leveling procedure if necessary.
|
|
|
| Figure 45 |
|
| Figure 44 | 1. | Deck lift arm | 3. | Deck hanger |
| 2. | Float retaining nut | 4. | Leveling adjust locking | |
1. Blades side to side | 3. | Measure here |
|
| nut |
|
|
|
2.Outside cutting edges
6. Check the | Adjusting the Blade Slope |
install the mower. If the front blade tip is not | 1. Check the |
install the mower. If the front blade tip is not | |
blade tip, adjust the blade level. If measurements | |
from steps 5 or 6 are out of range, then follow | blade tip, adjust the blade level using the following |
Adjusting the Blade Slope. | instructions: |
42