![](/images/new-backgrounds/1115688/11568885x1.webp)
Maintenance
2.Park the machine on a level surface and disengage the blade control switch.
3.Move the motion control levers outward to the neutral position, engage the parking brake, stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position.
4.Check the air pressure of all four tires. If needed, adjust to the recommended inflation; refer to Checking the Tire Pressure in Drive System Maintenance section.
5.Check and adjust the
6.Set the
7.Loosen the leveling adjust locking nuts (item 4) on all four corners so that the deck is sitting securely on all four blocks. Make sure that the deck hangers are all the way down (at the top of the slot) and the deck lift foot lever is pushed back against the stop, then tighten the four leveling adjust locking nuts (Figure 46).
Figure 46
1. | Deck lift arm | 3. | Deck hanger |
2. | Float retaining nut | 4. | Leveling adjust locking |
|
|
| nut |
8.Carefully rotate the blades so they are facing front to rear (Figure 47).
9.Measure from the tip of the front blade to the flat surface and the tip of the rear blade to the flat surface (Figure 47). If the front blade tip is not
|
| Figure 47 |
1. | Blades front to rear | 3. Measure here |
2. | Outside cutting edges |
10.When the
43