Model: | PV700HF |
Output Power (Maximum Continuous Watts)*: | 700 |
Output Power (Peak Watts)**: | 1400 |
Input Voltage (DC): | 12V nominal (10-15V) |
Output Voltage (AC)/Frequency: | 120V / 60 Hz. nominal |
Output Waveform: | PWM Sine Wave |
Low Battery Voltage Alarm (Volts): | 10.5V |
Low Battery Voltage Shutdown (Volts): | 10V |
AC Outlets: | 3 (NEMA 5-15R) |
Circuit Protection (Minimum DC Fuse Rating): | 125-amp fuse (external) |
Minimum Battery Cable Size: | 6 AWG (4 mm) |
Maximum Battery Cable Size: | 4 AWG (5 mm) |
Ground Cable Size: | 12-18 AWG (1-2 mm) |
Housing Material: | Extruded Aluminum |
*Maximum output power (continuous or peak) only available when vehicle battery is properly charged. Run vehicle engine often to maintain proper charge. ** Peak Output Power is instantaneous.
Typical Runtimes Before Battery Recharge
Although you can operate your Inverter with your vehicle engine off, best results are usually attained with the engine running. Since the Inverter converts electrical energy (and doesn’t produce it), the Inverter’s performance is relative to the condition of your vehicle’s electrical system (battery, alternator and wiring). If other loads (air conditioner, heater, lights, etc.) are also using power, you may get less runtime.
| With Typical | With Typical | With Typical |
| Compact Vehicle | Mid-Size Vehicle | Full-Size Vehicle |
| (4 cylinder) Battery, | (6 cylinder) Battery, | (8 cylinder) Battery, |
Model: PV700HF | Alternator & Wiring | Alternator & Wiring | Alternator & Wiring |
1/2 Load (engine ON) | continuous | continuous | continuous |
| | | |
Full Load* (engine ON) | 1-2 hours | 2-4 hours | continuous |
| | | |
1/2 Load (engine OFF) | not recommended | 1 hours | 2 hours |
| | | |
Full Load* (engine OFF) | not recommended | not recommended | 1 hour |
NOTE: You can maximize output power by following one or more of these steps: (1) connect multiple batteries to the Inverter; (2) keep batteries fully charged by running the vehicle's engine often; (3) install the Inverter as close to the batteries as possible; (4) connect the heaviest gauge cable possible to the Inverter's DC terminals; (5) use the Inverter in a vehicle with a heavy-duty alternator; (6) run the vehicle's engine at higher RPMs.
Battery Wiring Recommendations
For maximum efficiency, keep battery wires as short as possible. For very short runs, 6 AWG (4 mm) wiring may be adequate; for longer runs 4 AWG (5 mm) wiring is recommended. Acceptable output power is directly dependent on wire length: the shorter the wiring, the better the performance.
Limited Warranty and Warranty Registration
Tripp Lite warrants its Inverters to be free from defects in materials and workmanship for a period of 1 year from the date of initial purchase. Tripp Lite’s obligation under this warranty is limited to repairing or replacing (at its sole option) any such defective products. To obtain service under this warranty you must obtain a Returned Material Authorization (RMA) number from Tripp Lite or an authorized Tripp Lite service center. Products must be returned to Tripp Lite or an authorized Tripp Lite service center with transportation charges prepaid and must be accompanied by a brief description of the problem encountered and proof of date and place of purchase.
This warranty does not apply to equipment which has been damaged by accident, negligence or misapplication or has been altered or modified in any way, including opening of the unit’s casing for any reason. This warranty applies only to the original purchaser who must have properly registered the product within 10 days of purchase.
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Specifically, Tripp Lite is not liable for any costs, such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes, claims by third parties, or otherwise.
Warranty Registration
Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You'll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this product, always refer to the series number. The series number should not be confused with the marking name or model number of the product.
Tripp Lite follows a policy of continuous improvement. Product specifications are subject to change without notice.
