CAUTION

POTENTIAL HAZARD

Raising the mower deck for service or maintenance relying solely on mechanical or hydraulic jacks could be dangerous.

WHAT CAN HAPPEN

The mechanical or hydraulic jacks may not be enough support or may malfunction allowing the unit to fall, which could cause injury.

HOW TO AVOID THE HAZARD

DO NOT rely solely on mechanical or hydraulic jacks for support. Use adequate jack stands or equivalent support.

c)Clean out any grass build-up from underside of deck and in discharge chute.

5.1.5Check mower blades.

Service Interval: Daily

a)Stop engine, wait for all moving parts to stop, and remove key.

b)Lift deck and secure in raised position as stated in Section 5.1.4.

c)Inspect blades and sharpen or replace as required.

d)Re-install the blades (if they were removed) by placing a block of wood between the front or rear baffles and the blade then torque the blade bolts to 115-120 ft-lbs. (156-163 N-m). Be sure the spring disk washer cone is installed toward the bolt head (See Figure 7).

CAUTION

POTENTIAL HAZARD

Operating a mower deck with loose or weakened blade bolts can be dangerous.

WHAT CAN HAPPEN

A loose or weakened blade bolt could allow a blade rotating at a high speed to come out from under the deck, causing serious injury or property damage.

HOW TO AVOID THE HAZARD

Replace the blade bolt after striking a foreign object. Use only the following replacement parts:

Blade bolt – PN 103-0862

Spring disc washer – PN 103-0865

DO NOT lubricate the threads of the bolt or spindle before assembly.

Torque the blade bolt to 115-120 ft. lbs. (156-163 N-m)

- 25 -

Page 30
Image 30
Exmark Lazer Z XS manual Service Interval Daily