Sharpening the Blade

File the top side of the blade to maintain its original cutting angle (Fig. 22A) and inner cutting edge radius (Fig. 22B). The blade will remain balanced if you remove the same amount of material from both cutting edges.

A

1

B

2

 

 

153

m-4783

 

 

Figure 22

1.

Sharpen at this angle only

2. Maintain the original

 

 

 

radius here

Balancing the Blade

1.Check the balance of the blade by placing the center hole of the blade over a nail or screwdriver shank clamped horizontally in a vise (Fig. 23).

1007

Figure 23

Note: You can also check the balance using a commercially manufactured blade balancer.

2.If either end of the blade rotates downward, file that end (not the cutting edge or the end near the cutting edge). The blade is properly balanced when neither end drops.

Installing the Blade

1.Install a sharp, balanced Exmark blade, the accelerator, the lock washer, and the blade bolt. The sail of the blade must point toward the top of the lawn mower housing for proper installation. Torque the blade bolt to 50 ft-lb (68 N￿m).

Warning

Operating the lawn mower without the accelerator in place can cause the blade to flex, bend, or break, resulting in serious injury or death to the operator or bystanders.

Do not operate the lawn mower without the accelerator.

2.Return the lawn mower to its upright position.

3.Connect the wire to the spark plug.

Emptying the Fuel Tank and Cleaning the Fuel Filter

The fuel filter (screen) element is located inside the fuel tank. Clean the fuel filter element every 100 operating hours.

1.Stop the engine and wait for it to cool down.

Important Drain gasoline from a cold engine only.

2.Disconnect the wire from the spark plug (Fig. 10).

3.Close the fuel valve (Fig. 4).

4.Disconnect the fuel line (Fig. 29) by loosening the tube clamp at the carburetor.

5.Open the fuel valve by turning the lever to the open position (Fig. 8).

6.Drain the gasoline completely from the tank and fuel line into an approved fuel container.

7.Remove the fuel tank from the mower.

8.Close the fuel valve.

9.Pour a small amount of fuel in the fuel tank, move the fuel around in the tank, and pour it out into an approved fuel container.

10.Install the fuel tank and fuel line; refer to Installing the Fuel Tank and the Fuel Line on page 7.

Cleaning under the Belt Cover

Self-propel Model only

Keep the area under the belt cover free of debris.

1.Stop the engine and wait for all moving parts to stop.

2.Disconnect the wire from the spark plug (Fig. 10).

3.Remove the bolts that secure the belt cover (Fig. 24) to the lawn mower housing.

1

m-224

Figure 24

1. Belt cover

18

Page 22
Image 22
Exmark M216KA, M216KASP manual Emptying the Fuel Tank and Cleaning the Fuel Filter, Cleaning under the Belt Cover