Setup
B. Align the existing hole at the rear of the unit with the right hole on the bracket.
C. Position the bracket horizontally or with the narrow end pointed slightly downward.
D. Using the mounting bracket as a template, mark the left hole location onto the side panel of the unit and drill 11/32 inch diameter hole (see Figure 11).
Figure 11
1. | Drill | 3. | Mounting bracket |
2. |
| 4. | 5/16 inch nyloc nut |
| carriage bolt |
|
|
E.Align the two holes in the mounting bracket with the panel of the unit. Install
F.Insert the handle assembly into the mounting bracket as shown in Figure 12.
|
| Figure 12 |
|
1. | Handle assembly | 3. | Clevis pin |
2. | Mounting bracket | 4. | Hairpin |
G.Insert the clevis pin through the handle assembly hole, into the left hole of the mounting bracket, and through the panel of the unit. Secure the handle assembly with hairpin as shown in Figure 12.
H.Remove the nut from the front panel guard, install the loom clip, and replace nut as shown in Figure 13.
Figure 13
1. Front panel guard | 3. Nut |
2.Loom clip
I.Use velcro straps to secure the cable as shown in Figure 14.
Important: Keep the cable away from heat sources such as the muffler and manifold.
Important: Belt shields must be in place before operating the OCDWB01.
11
