Exmark TT23KCC, TT23KAC, TT20KCC manual Potential Hazard

WARNING

POTENTIAL HAZARD

♦Hydraulic fluid escaping under pressure can penetrate skin and cause injury.

WHAT CAN HAPPEN

♦Fluid accidentally injected into the skin must be surgically removed within a few hours by a doctor familiar with this form of injury or gangrene may result.

HOW TO AVOID THE HAZARD

♦Make sure all hydraulic fluid hoses and lines are in good condition an all hydraulic connections and fittings are tight before applying pressure to hydraulic system.

♦Keep body and hands away from pinhole leaks or nozzles that eject high pressure hydraulic fluid.

♦Use cardboard or paper, not your hands, to find hydraulic leaks.

♦Safely relieve all pressure in the hydraulic system by locking drive levers in neutral and shutting off the engine before performing any work on the hydraulic system.

5.1.10Change hydraulic system filter.

Service Interval: After First 250 hrs, then yearly thereafter.

Note: Use only Exmark P/N 1-513211 for Summer use above 32° F (0° C) or P/N 1-523541 for Winter use below 32° F (0° C). (Refer to Section 2.6.2 for filter specifications)

a)Place unit on a level surface. Stop engine, wait for all moving parts to stop, and remove key.

b)Carefully clean area around filter. It is important that no dirt or contamination enters the hydraulic system.

c)Unscrew filter to remove and allow oil to drain from reservoir.

IMPORTANT: Before re-installing new filter, fill it completely with Mobil 1 15W- 50 and apply a thin coat of oil on the surface of the rubber seal. Turn filter clockwise until rubber seal contacts the filter adapter. Do not tighten yet.

d)Fill reservoir as stated in Section 5.1.9.

e)Loosen filter 1/2 turn and allow a small amount of oil to leak from the oil filter (this allows air to be purged from the oil filter and supply hose from the hydraulic reservoir). Turn filter clockwise until rubber seal contacts the filter adapter. Then tighten the filter an additional 2/3 to 3/4 turn.

f)Raise the rear of the machine up onto jack stands high enough to raise the drive wheels off of the ground. Run machine to allow any other air to be purged from the hydraulic system and recheck the oil level.

g)If either drive wheel does not rotate, one or both of the charge pumps (located on the top of the main pump as shown in Figure 6) may have lost their “prime”. Refer to Section 5.1.11.

h)Do not change hydraulic system oil (except what can be drained when changing filter) unless it is felt that oil has been contaminated. Changing oil unnecessarily could damage the hydraulic system by introducing contaminates into the system.

-23 -