Note: To prevent damage due to freezing, battery should be fully charged before putting away for winter storage.

a)Check the voltage of the battery with a digital voltmeter. Locate the voltage reading of the battery in the table below and charge the battery for the recommended time interval to bring the charge up to a full charge of 12.6 volts or greater.

IMPORTANT: Make sure the negative battery cables are disconnected and the battery charger used for charging the battery has an output of 16 volts and 7 amps or less to avoid damaging the battery (see chart below for recommended charger settings).

Voltage

Percent

Maximum

 

Charging Interval

Reading

Charge

Charger Settings

 

 

 

12.6 or greater

100%

16 volts/7 amps

No Charging Required

12.4 – 12.6

75

– 100%

16 volts/7 amps

30 Minutes

12.2 – 12.4

50

– 75%

16 volts/7 amps

1

Hour

12.0 – 12.2

25

– 50%

14.4 volts/4 amps

2

Hours

11.7 – 12.0

0 – 25%

14.4 volts/4 amps

3

Hours

11.7 or less

0%

14.4 volts/2 amps

6

Hours or More

5.2ADJUSTMENTS

5.2.1Cutting height and anti-scalp roller adjustment.

WARNING

POTENTIAL HAZARD

When the two front support rod hairpins are removed from the mower deck, the weight of the tractor section may cause the front frame to rise suddenly

WHAT CAN HAPPEN

If the unit rises suddenly, injury may occur.

HOW TO AVOID THE HAZARD

Securely hold down the front of the unit when the front support rod hairpins are removed.

a)Stop engine and wait for all moving parts to stop.

b)Install hairpin clips in the holes for the desired cutting height (See Figure 11).

IMPORTANT: To maintain correct cutting height and rake, check the following for proper adjustment.

1.The front and rear hairpins are in the same holes with the proper spacers under the hair pins (See Figure 10).

2.The tire pressures are set as directed in Section 5.1.11.

3.The length of the rear deck support link assemblies are set to 6.89” (approximately 6 7/8”) from the center of the balljoint to the center of the furthest hole (See Figure 10).

- 32 -

Page 37
Image 37
Exmark TT3615KAC, TT4817KAEC, TT4817KAC, TT5217KAC, TT5217KAEC manual Adjustments