Quick Start — DAV/DAS101CM Series
CInstallation and service must be performed by authorized personnel only. These units must be installed in accordance with national and local electrical codes.
To install the DAV101CM and DAS101CM modules, see the appropriate section of this manual and follow these steps:
Step 1
Install an electrical box or wall bracket (if applicable) and cables. Use cable clamps to hold cables in place for strain relief. Trim back or insulate exposed cable shields with heat shrink to prevent short circuits. See pages
Step 2
Attach cables to the rear panel. Ensure that power and output cables have been fed through the wallbox/furniture and out the front of the faceplate, frame, or panel. Connect modules to each other (if applicable) and to the power supply, but do not apply power yet.
Connect output cables. See the diagrams here and on pages
Right, ring, – Right, tip, + Ground, sleeve(s), 
Left, ring, –
Left, tip, +
N
See caution. Right, tip, + Gnd, sleeve(s), 
See caution.
Left, tip, +
The channels of the
For unbalanced output, connect the sleeve to ground (Gnd, _). Connecting the sleeve to a negative
The pin assignments of the DAS’s power input and power
DAV’s power input.
POWER IN | DAV101CM |
+ 12V @0.3A | (back view) |
DAS101CM (back view)
Power In 
IN
OUT
Loop Out to DAV101CM or CIA Interface
12 VDC, 1 A
DC Power
Adapter
DAV101CM, DAS101CM • Quick Start Guide | iii |
