Extron electronic DAV101CM Series, DAS101CM Series user manual DAV-DAS power interconnection

Installation and Operation, cont’d

CThe pin assignments of the DAS’s power input and power loop-through ports are different from those of the DAV modules’ power input. Double-check your work against the wiring diagram. Power wires must be attached to the correct terminals on each connector or these products can be damaged.

TECHNICAL SUPPORT:

800.633.9876

714.491.1500

www.extron.com

MADE IN USA

POWER IN	DAV101CM
+ 12V @0.3A	(back view)

DAS101CM (back view)

Power In IN OUT

Loop Out to DAV101CM or CIA Interface

	12 VDC, 1 A
	DC Power
	Adapter
	DAV-DAS power interconnection
C	Audio output — Wire this 5-pole, 3.5 mm, direct insertion
	captive screw connector as shown below for either balanced or
	unbalanced stereo audio output.

Balanced

Stereo Output Wiring

Unbalanced

Stereo Output Wiring

12VDC

0.1 A

DAS101CM-1/-2/-5

Bottom View

12VDC

0.1 A

DAS101CM-3/-4/-6

Right, ring, –

Right, tip, +

Ground, sleeve(s),

Left, ring, –

Left, tip, +

See caution. Right, tip, + Gnd, sleeve(s),

See caution. Left, tip, +

NThe left and right channels of the DAS101CM-3/-4/-6 are reversed (R-L instead of L-R) relative to the DAS101CM-1/-2/-5, as shown above.

CFor unbalanced output, connect the sleeve to ground (Gnd, _). Connecting the sleeve to a negative (-) terminal will damage the audio output circuits.

2-6 DAV101CM, DAS101CM • Installation and Operation