Installation and Operation
Installation Overview
To install and set up an Extron
1Turn off all of the equipment. Ensure that the video sources and the output display are all turned off and disconnected from the power source.
2Mount the interface. See Mounting the Interface, below.
3Connect the cables. See Rear Panel Connections and Controls in this chapter.
4Plug in the power supply, then turn on the display devices and the input devices.
5Set the level and peaking. See Front Panel Controls and Indicator, on page
Mounting the Interface
CInstallation and service must be performed by authorized personnel only.
The 1" high,
Tabletop placement
Affix the four included rubber feet to the bottom of the unit and place it in any convenient location.
Rack mounting
6" Deep Rack Shelf
1/2 Rack Width Front False
Faceplate
Front false faceplate uses 2 screws.
(2)
Use 2 mounting holes on opposite corners.
Figure 2-1 — Mounting the unit on a 6-inch rack shelf
1U Universal Rack Shelf
1/2 Rack Width Front False
Faceplate
For optional rack mounting, mount the interface on any of the following rack shelves:
•RSU 126 6" 1U deep universal rack shelf kit (part
•RSB 126 6" 1U deep basic rack shelf (part
•RSU 129 9" 1U universal rack shelf kit (part
•RSB 129 9" 1U basic rack shelf (part
The interface can be mounted in the front or the rear of the
1. If installed, remove the feet from the bottom of the unit. |
Front false faceplate uses 2 screws.
Use 2 mounting holes on opposite corners.
(2)
NOTE: Using screws longer than 3/16” will damage the unit and void the warranty.
2. | Mount the interface using two |
| opposite (diagonal) corners to secure the unit to the shelf. |
3. | Install false faceplate(s) or other unit(s) to the rack shelf. |