DVI 104 Tx/Rx, cont’d
Features
Power Supply — Separate power supplies are provided for both the transmitter and receiver.
Power LEDs — The LEDs are on the top and bottom panels of both the receiver and transmitter. They illuminate blue when the unit is receiving power.
No mounting hardware required — The units plug directly into the source device (transmitter) or output device (receiver) and take up very little space.
EDID minder — The DVI 104 transmitter is able to capture and store the display device’s resolution and refresh rate, which ensures that the source boots up with the correct resolution.
Long cable runs — The DVI 104 Tx/Rx uses four fiber optic cables to extend video signals up to 1640' (500 m). The cables must be either 62.5/125 multimode cable or 50/125 multimode cable.
High resolution signal transmission — The units transmit signals at resolutions up to 1920 x 1200 or 1080p @ 60 Hz.
High rate of data transfer — The units can transmit signals at up to 1.65 Gbps
Front panel features
1 2
A | Power input — The transmitter and receiver both have plugs for |
| a 3.5 mm jack to provide 5 VDC to the unit. |
| The center pin of the jack carries +5 VDC; the outer shell of the |
| jack is the negative rail. |
| N If the PC or source is able to provide 5 VDC on pin 14 |
| of its DVI output, the transmitter can draw power from |
| the source device. If the source is a laptop or a PC using |
| a |
| enough power and the transmitter must be powered with |
| a separate external power supply. |
| The receiver must be powered by an external power |
| supply through the power input plug. |
