HSA 200/222 Series • Installation
HSA 200/222 Series • Installation
Installation, cont’d
2-6
Preparing the table with a hole saw (HSA 200C,HSA 200CE, or HSA 222C—US version only)1. Locate the desired mounting location on the tabletop or
other installation surface. Mark the 6" circle, then find the
center and mark it as well.
Wear safety glasses when operating the hole saw.
Failure to comply can result in eye injury.
2. Using a 6" hole saw on a portable drill, cut the mounting
hole at the desired location (figure 2-3). Extron is not
responsible for improperly positioned HSA products.
CAUTION
Use a portable drill with sufficient power for the 6"
hole saw. Exercise caution when handling the drill
and hole saw. Care should be taken to protect the
surface of the tabletop, podium, or other mounting
surface from damage.
Figure 2-3 — Cutting the opening with a hole saw
Installing the HSA enclosure (all)1. Remove the screw clamps (2) on the sides of the enclosure.
CAUTION
The flanged edges of the top of the surface enclosure
are bevelled to an ultra-fine thickness of less than
0.04 (4/100)" (approximately 1 mm), and are
therefore very sharp. These edges are also soft and
may be easily nicked or bent. Exercise caution
when handling and mounting the enclosure.
Mishandling may result in injury to the installer or
damage the appearance of the enclosure.
2. Remove the plastic strips that protect the corners of the
enclosure. If a sticky residue remains, remove it with an
appropriate metal cleaning product.
CAUTION
Do not use isopropyl alcohol or other solvents to clean
the HSA. Strong solvents will ruin some finishes.
3. Carefully lower the HSA enclosure into the hole to test the
fit. If necessary, remove the enclosure and use a file or
rasp to enlarge or smooth the edges of the opening.
4. From the underside of the table, reinstall the screw clamps
on the enclosure at a height at which the clamp will reach
the underside of the tabletop (figure 2-4).
Figure 2-4 shows an HSA 200 installation. Except for
the video and audio connectors, the HSA 222 installation
is identical.
Mounting
Surface
Output BNC
Connectors
(HSA 200 models only)
Screw Clamp
Display BNC
Connectors
(HSA 200 models only)
Power Cord
2 RJ-45 Connectors
Audio Cable
(HSA 200 models only)
Extron
HSA 200
Hideaway Surface
Access Enclosure
C
AT6