Installation and Operation, cont’d
Installing Batteries in the Remote Control
The IR 102 handheld remote control is shown below.
1 | INPUT/OUTPUT SELECTION | 4 | |
2 | 3 | ||
5 | 6 | 7 | 8 |
9 | 0 | +10 | ENTER |
IR 102
Universal Remote
IR 102 remote control
Install two AAA batteries in the remote as shown below. The battery compartment is in the front, bottom side of the remote control.
Installing batteries in the IR 102 remote control
Operation
To select an input using the IR 102 remote control, aim the handheld unit at the IR detector and press the numeric button for the desired input. For switchers with ten or more inputs, press the +10 key to add ten to the input number selected. For example, to select input 17, press the +10 key, then the 7 key. The maximum operating range is 30 feet.
Working with a control system
Up to 21' Cable
IR 102 Universal Remote |
|
|
|
|
|
IR 102 Remote Control IR Sensor | IR 102 Rx UNIVERSAL IR REMOTE RECEIVER |
| |||
| Control System/PC | ||||
|
|
|
|
| |
|
|
| IR IN | CONTROL OUT |
|
| POWER | MOD | DEMOD | IN | |
| .5A MAX | CONTACT | 6' Cable | ||
| 12V |
|
|
|
|
Power Supply | +12V | +5 | 1 | 2 | 3 | 4 | 5 | 6 | Tx Rx | OUT | |
|
|
|
|
|
|
|
|
|
| CONTACT |
IR 102 Rx Remote |
|
|
| REMOTE |
| INPUTS | REMOTE | SW6VGAArsArs | |
Control Receiver | 1 | 3 | OUTPUT | OUTPUT |
| 5 |
| ||
| 2 | 4 | 6 | L R |
| SW6 VGA Ars Switcher |
| ||
A typical IR 102 Kit application
The IR 102 remote receiver connects via cable to the switcher’s rear panel
NThe remote control can operate a switcher only if the switcher is configured as master, with no switchers slaved to it. Refer to the switcher’s manual for information on switcher configuration.
IR 102 Remote Control Kit • Installation and Operation |
