Extron electronic IR 102 user manual Installation and Operation, cont’d, Extron

Installation and Operation, cont’d

	Mounting
Projector	Bolt
Mounting	Extron
Bracket	IR 102 RX
	Remote Receiver

Projector

Projector mounting the IR 102 Rx using the PMK 100 mini projector mounting kit (#70-217-01)

Mounting using the PMK 300 projector mounting kit

Alternatively, the IR 102 Rx remote receiver can be projector mounted using the optional PMK 300 multi-product projector mounting kit, part #70-374-01.

NOnly VersaTools products and most IP Link products can be mounted using the multi-product projector mounting kit.

The PMK 300 multi-product projector mounting kit (#70-374-01) mounts up to three quarter-rack width products to a projector ceiling mount pole. The IR 102 Rx can be mounted above the display device with the front panel facing either down or up. The quarter rack width plate can also be used to mount the

IR 102's external desktop power supply.

Side Mounting

Plate

Countoured

Bracket

Base

U-bolt

Extron

IR 102

Rx Remote Receiver

Power Supply

Extron

PMK 300

Multi-product Projector Mount Kit

Front Mounting

Plate

Projector-mounting the IR 102 Rx using the PMK 300 projector mounting kit (#70-374-01)

Follow these steps to mount the IR 102 Rx receiver using the PMK 300:

1.If necessary, remove the feet from the bottom of the IR 102.

2.Mount the IR 102 to one of the bracket’s three mounting plates, using two of the supplied 4-40 x 3/16" screws in opposite (diagonal) corners to secure the device to the bracket. It can be vertically mounted facing either up or down. See the illustration, above.

•On the side mounting plates, the IR 102 is typically mounted on the outside of the bracket.

•On the front mounting plate, the device is typically mounted on the inside of the bracket.

3.Using the two included tie wraps, strap the power supply to one of the brackets.

4.Place the contoured bracket base against the projector ceiling pole and opposite the back plate. The pole should fit snugly into the depression in the center of the contoured base.

1-6 IR 102 Remote Control Kit • Installation and Operation IR 102 Remote Control Kit • Installation and Operation 1-7