Installation and Operation, cont’d
NThe PMK 300 has a hole in the bottom plate that allows the projector pole to be inserted through the center of the plate, rather than outside of the plate (see the illustration below). To install the PMK 300 in this configuration, slide the bracket up from the bottom of the pole before the projector is installed on the pole.
Mounting using the PMK 350 projector mounting kit
The IR 102 Rx can also be mounted using the PMK 350, as shown below.
Mount Plate |
| |
Flange | Extron | |
Rear Plate | IR 102 Rx | |
Remote Receiver | ||
Mounting Tray | ||
|
Contoured
Bracket
Base
Extron
IR 102 Rx
Remote Receiver
Contoured |
Bracket |
Base |
Power Supply
| Extron |
PMK 300 | |
|
Mount Kit
Mounting the IR 102 Rx using the PMK 300 with the projector pole passing through the center
Extron |
| Bracket |
|
| |
PMK 350 |
| |
|
| |
Mounting Kit |
|
|
| Extron |
|
| Power Supply | Front Plate |
Overlay Sheet
Projector mounting the IR 102 Rx using the PMK 350 projector mounting kit,
The PMK 350 low profile projector mounting kit is an above- projector mounting kit that attaches to a 1.5" to 2" diameter projector mounting pole. It can hold more than one device, in a variety of sizes.
The PMK 350 is available in black (part
Follow these steps to mount the IR 102 Rx on the PMK 350:
1. | Remove the front panel from the PMK, using a #2 Philips |
| screwdriver. Retain the four screws to reattach the plate |
| when finished. |
2. | Remove any rubber feet from the bottom of the IR 102 Rx. |
3. | Secure the IR 102 Rx to one side of the mounting bracket, |
| using two of the supplied |
| (diagonal) corners. Use an Extron Tweeker (provided) or a |
| Philips #1 screwdriver to tighten the screws. |
4. | Using the two included tie wraps, strap the IR 102 Rx |
| power supply to the PMK bracket. |
IR 102 Remote Control Kit • Installation and Operation | IR 102 Remote Control Kit • Installation and Operation |