Extron electronic IR 102 user manual Installation and Operation, cont’d, Furniture mounting

Installation and Operation, cont’d

Furniture mounting

Furniture mount the IR 102 Rx remote receiver using optional mounting kit #70-212-01 as follows:

VersaTools Rack Shelf

Quarter Rack Wide

1.Attach the mounting brackets to the remote receiver with the provided machine screws.

2.If rubber feet were previously installed on the bottom of the remote receiver, remove them.

MBU 123

Under Desk Mounting Kit

False Front Face Plate

Use 2 mounting holes on

opposite corners.

(2) 4-40 x 3/16" Screws

Mounting the IR 102 Rx remote receiver on a VersaTools rack shelf

NOnly products in the VersaTools line and certain IP Link products can be mounted to a VersaTools shelf. Any 1U rack-mountable Extron product can be mounted on the standard shelf.

1U Universal Rack Shelf

1/2 Rack Wide Front False

Faceplate

1/4 Rack Wide Front False

Faceplate

Both front false faceplates use 2 screws.

	(2) 4-40 x 3/16"
Use 2 mounting holes on	Screws
opposite corners.

Mounting the IR 102 Rx remote receiver on a standard rack shelf

3. Hold the remote receiver Under Desk Mounting

with the attached brackets against the underside of the

table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.

4.Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.

5.Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4" of the screw head protrudes.

6.Align the mounting screws with the slots in the brackets and place the remote receiver against the surface, with the screws through the bracket slots.

7.Slide the receiver slightly forward or back, then tighten all four screws to secure the remote receiver in place.

Projector mounting

Projector mounting procedures differ depending on the mounting kit you use.

Mounting using the PMK 100 mini projector mounting kit

Projector mount the IR 102 Rx using optional PMK 100 mini Projector mounting kit, part #70-217-01, as follows:

1.Attach the mounting brackets to the IR 102 remote receiver with the provided machine screws.

2.If rubber feet were previously installed on the bottom of the receiver, remove them.

3.Secure the remote receiver to a projector mount or other surface by inserting the mounting bolt through the bracket’s slotted hole and tightening the bolt. (See the illustration on the next page.)

1-4 IR 102 Remote Control Kit • Installation and Operation IR 102 Remote Control Kit • Installation and Operation 1-5