The rear panels of the USB HUB4 AAP and MAAP models contain two types of USB In connectors, either of which can be used for the USB cable that connects your computer to the HUB4.
A | Power connector — If using an Extron external 12 VDC power supply to |
| power the HUB4, connect it to the first two pins (labeled In) of this |
| 3.5 mm direct insertion captive screw connector. (See “Connecting to the |
| captive screw USB connector”, below) |
| If desired, connect another Extron wall mounted device (for example, an |
| MLC 104 IP Plus AAP to which you have mounted the HUB4) to the third and |
| fourth pins (labeled Out). Both devices can then be powered from the single |
| connected power supply (power loop out). |
| (If the HUB4 is powered from your computer via the USB connection, this |
| connector is not used.) |
NEnsure that your system’s power requirements do not exceed the capacity of the Extron 12 VDC power supply. The current is limited to 100 mA per port when the devices are powered via the USB port; 500 mA per port when they are powered via the power supply.
USB In connectors
Two types of USB connectors provide alternative ways to connect the computer to the HUB4.
B | Captive screw connector — Connect a Type A to unterminated Type B or |
| mini B USB cable from the computer to this |
| connector. (See “Connecting to the captive screw USB connector”, below.) |
C | Type mini B USB connector — Connect a Type |
| the computer to this Type mini B USB connector. |
NOnly one host can be connected to the USB In connectors at a time. If two hosts are connected, the HUB4 defaults to the host attached to the Type mini B connector.
Connecting to the captive screw USB connector
It is recommended that you connect your computer to the HUB4 by plugging the mini Type B end of the provided USB cable to the USB port on the rear panel. If, however, your space is limited and you need to use the captive screw USB In connector instead, prepare and connect the cable as follows:
1.Cut off the Type B end of a Type
2.Strip away the exterior jacket and the foil insulation from the unterminated end of the cable to expose 1 to 2 inches (or 3 to 6 cm) of the wires and shield.
CDo not cut or remove the braided shield.
PRELIMINARY
USB HUB4 Series • Installation |