Remote Control, cont’d
After receiving the arp
NYou must ping the CrossPoint or MAV switcher BME as shown in step 5 for the IP address change to take place. The response should show the new IP address, as shown in the following figure.
5.Execute a ping command by entering “ping” followed by a space and the new IP address at the command prompt. For example:
ping 10.13.197.7
C:\>ping 10.13.197.7
Pinging 10.13.197.7 with 32 bytes of data:
Reply from 10.13.197.7: bytes=32 time<10ms TTL=128
Reply from 10.13.197.7: bytes=32 time<10ms TTL=128
Reply from 10.13.197.7: bytes=32 time<10ms TTL=128
Reply from 10.13.197.7: bytes=32 time<10ms TTL=128
Ping statistics for 10.13.197.7:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in
Minimum = 0ms, Maximum = 0ms, Average = 0ms
NYou can reconnect using either Telnet or a Web browser to verify that the update was successful.
6.After verifying that the IP address change was successful, enter and issue the
or
4-14 CrossPoint / MAV Matrix Switchers • Remote Control
Loading the start-up page
NIf your Ethernet connection to the matrix switcher is unstable, try turning off the proxy server in your Web browser. In Microsoft Internet Explorer, click Tools >
Internet Options > Connections > LAN Settings, uncheck the Use a proxy server... box, and then click
OK.
NFor details on operating the switcher via HTML pages, refer to the CrossPoint 450 Plus / MAV Plus Switcher Manual, chapter 6, “HTML Operation”.
1. | Start the Web browser program. |
2. | Click in the browser’s Address field. |
3. | Enter the Matrix IP address in the browser’s Address field. |
N192.168.254.254 is the
4. | Press the keyboard Enter key. The switcher checks to see if |
| it is password protected. |
If the switcher is not password protected, it checks and downloads the HTML
If the switcher is password protected, the switcher downloads the Enter Network Password page.
NA User name entry is not required.
5. | Enter the appropriate administrator or user password in |
| the Password field and click OK. |
6. | The switcher downloads the HTML |
| switcher is ready for operation via HTML remote control. |
CrossPoint / MAV Matrix Switchers • Remote Control
Refer also to the CrossPoint 450 Plus / MAV Plus User’s Manual at www.extron.com. | Refer also to the CrossPoint 450 Plus / MAV Plus User’s Manual at www.extron.com. |