Installation and Operation, cont’d
6" Deep Rack Shelf | 1/2 Rack Width Front False |
| Faceplate |
Front false faceplate uses 2 screws.
(2)
Use 2 mounting holes on opposite corners.
Mounting an MDA EQ on a
Furniture mounting
3. | Hold the unit with the attached brackets against the |
| underside of the table or other furniture. On the mounting |
| surface, mark the location of the bracket’s screw holes. |
4. | Drill 3/32" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep |
| in the mounting surface at the marked screw locations. |
5. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until slightly less |
| than ¼" of the screw head protrudes. |
6. | Align the mounting screws with the slots in the brackets |
| and place the unit against the surface, with the screws |
| through the bracket slots. |
7. | Slide the unit slightly forward or back, then tighten all |
| four screws to secure it in place. |
Projector mounting
To
PMK 100 Mini Projector Mounting Kit
The PMK 100 is a projector mounting kit (part
To
Projector
Mounting
Bracket
Projector
Mounting Bolt
Preparing the MDA EQ for
1. | If rubber feet were previously attached to the bottom of the |
| unit, remove them. |
2Attach the mounting brackets to the MDA EQ with the provided machine screws as shown in the previous figure.
Follow these steps to
1. If rubber feet are attached to the bottom of the MDA EQ, remove them.
VersaTools® MDA EQ Series • Installation and Operation | VersaTools® MDA EQ Series • Installation and Operation |