Extron electronic MDA 2V EQ Installation and Operation, cont’d, PMK 300 Projector Mounting Kit

Installation and Operation, cont’d

2.	Attach the projector mounting bracket to the side of the
	MDA EQ, using the provided machine screws.
3.	Secure the unit to a projector mount or other surface by
	inserting the mounting bolt through the bracket’s slotted
	hole.

See the illustration on the previous page.

PMK 300 Projector Mounting Kit

The PMK 300 Multi-Product Projector Mounting Kit

(#70-374-01) mounts up to three quarter-rack width products to a projector ceiling mount pole. The MDA EQ can be mounted above the display device with the front panel facing either down or up. The quarter rack width plate can also be used to mount the MDA external desktop power supply.

Side Mounting

Plate

Countoured

Bracket

Base

	•	On the side mounting plates, the MDA is typically
		mounted on the outside of the bracket.
	•	On the front mounting plate, the device is typically
		mounted on the inside of the bracket.
3.	Using the two included tie wraps, strap the power supply
	to one of the brackets.
4.	Place the contoured bracket base against the projector
	ceiling pole and opposite the back plate. The pole should
	fit snugly into the depression in the center of the
	contoured base.

NThe PMK 300 has a hole in the bottom plate that allows the projector pole to be inserted through the center of the plate, rather than outside of the plate (see the illustration on the next page). To install the PMK 300 in this configuration, slide the bracket up from the bottom of the pole before the projector is installed on the pole.

U-bolt

Extron

MDA EQ Series

Mini Distribution Amplifier

Contoured

Bracket

Base

Extron

MDA EQ Series

Mini Distribution Amplifier

Power Supply

Extron

PMK 300

Multi-product Projector Mount Kit

Front Mounting

Plate

Projector-mounting the MDA EQ using the PMK 300 Projector Mounting Kit

Follow these steps to mount the MDA EQ using the PMK 300:

1.	If necessary, remove the feet from the bottom of the MDA.
2.	Mount the MDA to one of the bracket’s three mounting
	plates, using two of the supplied 4-40 x 3/16" screws in
	opposite (diagonal) corners to secure the device to the

bracket. It can be vertically mounted facing either up or down. See the illustration, above.

Power Supply

	Extron
U-bolt	PMK 300

Multi-product Projector

Mount Kit

Mounting the MDA EQ using the PMK 300 with the projector pole passing through the center

2-6 VersaTools® MDA EQ Series • Installation and Operation VersaTools® MDA EQ Series • Installation and Operation 2-7