Installation and Operation, cont’d
3. | Secure the unit to a projector mount or other surface by |
| inserting the mounting bolt through the bracket’s slotted |
| hole. |
Rear Panel Features and Cabling
The following figures show the back panel configurations of the three MDA EQ models.
6
| 7 | |
MDA 4SV EQ | INPUT | |
| ||
POWER | IN | |
HIGH Z | ||
12V | ||
0.2A MAX |
| |
| 75 Ohm | |
|
OUTPUTSOUTPUTS
1 3
2 4
MDA 2V EQ | INPUT | OUTPUTS |
| |
|
|
|
| |
POWER | IN | HIGH Z | 1 | 4 |
12V |
|
|
| |
0.2A MAX |
|
|
|
|
|
| 75 Ohm | 2 |
|
1 | 2 | 3 |
|
|
MDA 2V EQ rear panel
6
MDA 4V EQ | INPUT | OUTPUTS |
|
|
|
| |
POWER | IN | 1 | 3 |
12V |
| HIGH Z |
|
0.2A MAX
| 75 Ohm | 2 | 4 | |
|
|
|
| |
1 | 2 | 3 |
| 4 |
MDA 4V EQ rear panel
1 | 2 | 3 | 5 |
MDA 4SV EQ rear panel
1Power connector — Plug the external 12 VDC power supply into this
To wire the connector:
1. Cut the DC output cord to the length needed.
2. Strip the jacket to expose 0.2 inches (5 mm) of the conductors.
Exposing more than 0.2" (5 mm) of the copper wires could allow the stripped wires to touch each other, causing a short circuit. This could result in the external DC power supply overheating and/or burning.
Stripping the wires to expose less than the recommended amount causes them to slide out of the connector too easily, even if they are tightly pinched by the captive screws.
3. Slide the leads into the supplied captive screw plug and lock them, using an Extron Tweeker (small screwdriver).
4. To verify the power cord’s polarity before connecting it, plug in the power supply with no load and check the output with a voltmeter.
The figure on the next page shows how to wire the connector.
VersaTools® MDA EQ Series • Installation and Operation | VersaTools® MDA EQ Series • Installation and Operation |