Extron electronic MDA 2V EQ Installation and Operation, cont’d, Mounting the MDA EQ Series

Installation and Operation, cont’d

Mounting the MDA EQ Series

The MDA EQ mini distribution amplifiers can be set on a table; mounted on a rack shelf; attached to a projector; or mounted under a desk, podium, or tabletop.

Tabletop use

Four self-adhesive rubber feet are included with the MDA EQ. For tabletop use, attach one foot at each corner of the bottom side of the unit and place the unit in the desired location.

Rack mounting

For rack mounting, do not install the rubber feet. Mount the distribution amplifier on a 19" 1U VersaTools® rack shelf (Extron part #60-190-20or 60-604-20), a standard 1U Universal or Basic rack shelf (Extron part #60-190-01or 60-604-01), or a Universal or Basic 6-inch Deep Rack Shelf (Extron part #60-190-10or 60-604-10).

		Only products in the VersaTools and IP Link lines can be
		mounted on a VersaTools shelf. Any 1U rack-mountable
		Extron product can be mounted on the standard shelf.
1.	If feet were previously installed on the bottom of the
	MDA, remove them.
2.	Mount the MDA EQ on the rack shelf, using two 4-40 x
	3/16" screws in opposite (diagonal) corners to secure the
	unit to the shelf.
3.	Install blank panel(s) or other unit(s) on the rack shelf.

VersaTools Rack Shelf

1/4 Rack Width Front

False Faceplate

Use 2 mounting holes on

opposite corners.

(2) 4-40 x 3/16" Screws

Mounting MDAs on a VersaTools rack shelf

1U Universal Rack Shelf

1/2 Rack Width Front False

Faceplate

1/4 Rack Width Front False

Faceplate

Both front false faceplates use 2 screws.

	(2) 4-40 x 3/16"
Use 2 mounting holes on	Screws
opposite corners.

Mounting an MDA EQ on a standard rack shelf

2-2 VersaTools® MDA EQ Series • Installation and Operation VersaTools® MDA EQ Series • Installation and Operation 2-3