Extron electronic MDA 4V EQ Projector mounting, Furniture mounting, Projector-mountingan MDA EQ

Installation and Operation, cont’d

6" Deep Rack Shelf	1/2 Rack Width Front False
	Faceplate

Front false faceplate uses 2 screws.

(2) 4-40 x 3/16" Screws

Use 2 mounting holes on opposite corners.

Mounting an MDA EQ on a 6-inch rack shelf

2Attach the mounting brackets to the MDA EQ with the provided machine screws as shown in the previous figure.

3.	Hold the unit with the attached brackets against the
	underside of the table or other furniture. On the mounting
	surface, mark the location of the bracket’s screw holes.
4.	Drill 3/32" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep
	in the mounting surface at the marked screw locations.
5.	Insert #8 wood screws into the four pilot holes. Tighten
	each screw into the mounting surface until slightly less
	than ¼" of the screw head protrudes.
6.	Align the mounting screws with the slots in the brackets
	and place the unit against the surface, with the screws
	through the bracket slots.
7.	Slide the unit slightly forward or back, then tighten all four
	screws to secure it in place.

Projector mounting

To projector-mount the MDA EQ, use the optional projector mounting kit (part # 70-217-01) as follows.

Furniture mounting

To furniture-mount the MDA EQ, use the optional under-desk mounting kit (part #70-212-01), as follows.

Projector

Mounting

Bracket

Ceiling

Projector

Mounting Bolt

Preparing the MDA EQ for under-desk mounting

1.	If rubber feet were previously attached to the bottom of the
	unit, remove them.

Projector-mounting an MDA EQ

1.	If rubber feet were previously installed on the bottom of
	the unit, remove them.
2.	Attach the mounting brackets to the MDA EQ with the
	provided machine screws.

2-4 VersaTools® MDA EQ Series • Installation and Operation VersaTools® MDA EQ Series • Installation and Operation 2-5