Audio and video signals can be switched separately (broken away from each other) via the User Mode screen of the control software. If the signals are switched separately, the LED above the audio input’s button blinks, and the LED above the video input’s button lights steadily.
The labels above the LEDs can be replaced. See appendix B in this manual for details.
3LCD— This
EXTRON MLS 506
2sec.
2sec.
INPUT
#6
4Menu button — Press this button to enter the setup menus and to move from menu to menu. The Menu and Next buttons are also used to enable/disable the executive mode. See the note below.
5Next button — When the MLS’s setup menus are active, press this button to enter a specific submenu or to move between options within a submenu.
Press the Menu and Next buttons simultaneously for three seconds to enable/ disable the executive mode. When executive mode is enabled, adjustments and changes to switcher setup cannot be made from the front panel controls. Only input selection and adjustments to overall volume and mixer levels are allowed. See page
6Mix knob (MLS 506 MA and MLS 506 SA only) — Turn this knob to adjust the level of the Aux/Mix audio input. This control determines how much gain or attenuation is applied to the Aux/Mix channel and, therefore, how loud the auxiliary audio sounds. This knob has no function during setup.
There is no physical limit to this knob’s rotation. During mix level adjustment the LCD screen displays the level (shown below), and also indicates when the knob has reached its functional minimum (0) or maximum (100) limit.
Mix
Min
Attenuation
MIX
Mix 014
MIX
Mix 050
MIX
Mix 079
MIX
Mix
Max
Gain
7Volume/Adjust(ment) knob — While in the regular operating mode, turn this knob to adjust the master audio volume for the Audio Out preamp audio outputs (and the amplified output on the MA and SA models). There is no physical limit to this knob’s rotation. During volume adjustment the LCD screen displays the level (shown below), and also indicates when the knob has reached its functional minimum (0) or maximum (100) limit. The minimum setting produces 100% signal attenuation.
Volume
Min
100%
attenuation
VOLUME
ADJUST
Volume
007
VOLUME
ADJUST
Volume
050
VOLUME
ADJUST
Volume
086
VOLUME
ADJUST
Volume
Max
0%
attenuation
When the setup menus are active, turn the Volume/Adjust knob to make adjustments to switcher settings.
8Clip LED (MLS 506MA and MLS 506SA only) — This LED flashes when the audio level for a particular input is too high. If the audio level exceeds the point at which the Clip LED flashes, the audio will be clipped, which results in a distorted output. Adjust the output level of the active source or the input level at the switcher (via the front panel LCD Audio Adjust menu or via the control software) so clipping does not occur.
MediaLink Switchers • Operation |