Extron electronic MPS 409 manual Installation, Mounting the Switcher, UL Rack Mounting Guidelines

Installation

This section describes the installation and the operation of the MPS 409, including:

•Mounting the Switcher

•Rear Panel Connections

•Cabling the MPS 409 Switcher

Mounting the Switcher

The MPS 409 is housed in 1U, full rack width metal enclosure rack- or desk-mountable. The MBD 149 1U through-desk and rack mounting kit (#70-077-03) is included with the switchers. The switchers may also be surface‑mounted under a table, desk, or podium, or on a wall, using the optional MBU 149 1U under-desk mounting kit (#70-222-01).

Mounting Screws (2 Plcs)

Each Side

Optional Furniture Mounting Bracket

-or-

#8 Screw (4 Plcs)

Each Side

Supplied Rack Mounting Bracket

.2A

-240V 100

Hz 50/60

VIDEO1

				L
			1
			OUTPUT	R
			3
			1
		HDMI	2
		3	OUTPUT
			2
	1	OUTPUT
	OUTPUT
2	2

	1
OUTPUT	OUTPUT
VGA/YUV	2

2 OUTPUT 1

2

1 DVI -D

1

OUTPUT

2	L
L
	R
R

MIC/LINE	LINE
ON
OFF	MIC

-232 RS

Figure 2. Mounting the MPS switcher

UL Rack Mounting Guidelines

The following Underwriters Laboratories (UL) guidelines pertain to the safe installation of the MPS 409 in a rack.

1.Elevated operating ambient temperature — If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient temperature. Therefore, install the device in an environment compatible with the maximum ambient temperature (Tma = +122 °F, +50 °C) specified by Extron.

2.Reduced air flow — Install the equipment in a rack so that the amount of air flow required for safe operation of the equipment is not compromised.

MPS 409 • Installation 4