Extron electronic MTP R 15HD RSA D Installation and Operation, cont’d, Final installation

Installation and Operation, cont’d

5. Secure the wall box with nails or screws, leaving the front edge flush with the outer wall or furniture surface. See figure 2-2.

Wall Stud	Wall Stud
Signal	Signal
	Output
Output
	Cable
Cable
Cable	Cable
Clamp	Clamp
Screws	Screws
	or Nails
or Nails

10. Connect a video and an RS-232 and/or audio device to the front panel (see "Front panel features", later in this chapter, for connector details).

11. Restore the power supply, and test the transmitter/receiver system. Make any cabling adjustments before final installation, as the cables will be inaccessible afterwards.

Final installation

After testing and making any adjustments, do the following:

1. At the power outlet, unplug the power supply.

2. Mount the receiver into the box, and attach the supplied Decora faceplate to the unit, as shown in figure 2-3.

Figure 2-2 — Installing the wall box

NIf attaching the wall box to wood, use four #8 or #10 screws or 10-penny nails. A minimum of 0.5" (1.3 cm) of screw thread must penetrate the wood.

If attaching the wall box to metal studs or furniture, use four #8 or #10 self-tapping sheet metal screws or machine bolts with matching nuts.

6. Feed the power cable through the opening and through the wall box punch-out holes into the box, securing the cable

Wall Box

Wall opening is flush with edge of box.

Extron

MTP R 15HD RSA D

PEAK

LEVEL

-232 RS

AUDIO

Rx

Tx

OUTPUT

Decora

Faceplate

with cable clamps to provide strain relief.

NIn order to fit in the junction box, the TP cable and RJ-45 connector should not have a boot installed.

7. Feed the twisted pair cable pigtail out through the wall box punch-out holes, securing the pigtail with cable clamps to provide strain relief.

8. Trim back and/or insulate exposed cable shields with heat shrink to reduce the chance of short circuits.

To prevent short circuits, the outer foil shield can be cut back to the point where the cable exits the cable clamp.

9. Connect the power cable to the rear of the unit and the TP cable to the RJ-45 pigtail. See "Rear panel features", later in this chapter, for connector wiring details.

Figure 2-3 — Mounting the receiver

3. At the power outlet, reconnect the power supply.

2-4 MTP R 15HD RSA D • Installation and Operation MTP R 15HD RSA D • Installation and Operation 2-5