Extron electronic MTP R 15HD RSA D Installation and Operation, cont’d Connections and Settings

Installation and Operation, cont’d

Connections and Settings		Vertical Sync switch (2) — Set this switch on (right) for positive
See figure 2-4 to identify the rear and front panel connections on		vertical sync or off (left) for negative sync.
the receiver.		N Most devices use negative sync.
		N Set the Composite Sync, SOG, and Video DIP switches
MTP 15HD RSA D Rx Rear Panel	MTP 15HD RSA D Rx Front Panel	as shown in the table below for the various input and
		output video formats.
		Composite Sync switch (3) — Set this switch on (right) for
2		RGBS or off (left) to output RGBHV or RGsB video. See the
		table below.

			7	LEVEL	PEAKING	Input signal	Output signal	Receiver's DIP
H SYNC +			6
		INPUT
						format to the	format from	switch settings
V SYNC +
	3			AUDIO RS-232
C SYNC		H SYNC +				transmitter	the receiver	C Sync	SOG	Video
SOG		V SYNC +	5
		C SYNC
VIDEO		SOG			Tx Rx		RGBHV
Bi-RS232		VIDEO		OUTPUT
		Bi-RS232
			4			RGBHV	RGBS
	1						RGsB
						RGBS	RGBS
							RGsB
	Figure 2-4 — Receiver’s features					RsGsBs	RsGsBs
						RGsB	RGsB

Rear panel features		Component	Component
A	DC power connector — If applicable, plug the external 12 VDC
		S-video	S-video
	power supply into this 2-pole captive screw connector. See
	"Power supply wiring" on page 2-9 to wire the connectors.	Composite	Composite

NThe remote power capabilities available with certain

	MTP models are not supported by this unit; the	Sync-on-Green (SOG) switch (4) — Set this switch on (right) for
	transmitter and receiver both must be powered.
		RGsB video (when the input is RGBHV or RGBS) or off (left) to
B	Input connector — Connect the TP cable from the transmitter to	output RGBHV, RsGsBs, or RGBS video. See the table above.
	this pigtail RJ-45 female connector. See “TP cable termination”	Video switch (5) — Set this switch on (right) for RsGsBs, RGsB,
	on page 2-10 to wire the RJ-45 connectors.
		component/S-video/composite video or off (left) to output
	N See the table on page 1-4 for recommended transmission	RGBHV or RGBS video. See the table above.
	ranges.	BI-RS232 (6) — Set this switch on (right) to select bidirectional
C DIP switches
		communications when serial data is present on the audio/
	Horizontal Sync switch (1) — Set this switch on (right) for	RS-232 wire pair. Set the switch off (left) to select unidirectional
		communications. The default position is off (left).
	positive horizontal sync (or positive composite sync if the

Composite Sync switch is also on) or off (left) for negative sync.	N This switch is ignored if audio is present on the audio/
	RS-232 wire pair.

NMost devices use negative sync.

2-6 MTP R 15HD RSA D • Installation and Operation MTP R 15HD RSA D • Installation and Operation 2-7