ASSEMBLY
UNPACKING
This product requires assembly.
Carefully remove the tool and any accessories from the box. Place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, keep your knees bent and lift with your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Loose Parts List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer instal- lation. Use of a product that may have been improperly assembled could result in serious personal injury.
Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
Do not discard the packing material until you have carefully inspected the tool, identified all loose parts, and satisfactorily operated the tool.
NOTE: A box containing some of the Loose Parts is inside the saw cabinet. Also, remove the foam blocks from between the saw’s housing and motor by beveling the blade (see page 26).
The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has influenced the settings, refer to specific procedures explained in this manual.
If any parts are damaged or missing, please call
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such altera- tion or modification is misuse and could result in a hazard- ous condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury.
WARNING:
Never stand directly in line with the blade or allow hands to come closer than 3 in. to the blade. Do not reach over or across the blade. Failure to heed this warning can result in serious personal injury.
WARNING:
To avoid serious personal injury, always make sure the table saw is securely mounted to a workbench or an approved leg stand. NEVER operate the saw on the floor.
Mounting Holes
This tool comes mounted to a leg stand. If you chose to remove the leg stand, the table saw must be mounted to a firm supporting surface such as a workbench. Four bolt holes have been provided in the saw’s base for this pur- pose. Each of the four mounting holes should be bolted securely using 5/16 in. machine bolts, lock washers, and hex nuts (not included). Bolts should be of sufficient length to accommodate the saw base, lock washers, hex nuts, and the thickness of the workbench. Tighten all four bolts securely.
Carefully check the workbench after mounting to make sure that no movement can occur during use. If any tipping, sliding, or walking is noted, secure the workbench to the floor before operating.
to attach the wheel assembly
See Figure 6.
nLocate the bolt screwed through the leg stand and saw cabinet on the left side of the saw.
nUnscrew the bolt then remove bolt, spacers, and flat washers from the saw.
nPlace a flat washer on the bolt then slide the bolt/washer into the hole in the center of the wheel.
nPlace a second flat washer then small spacer on the bolt.
nSlide the bolt into the leg stand and large spacer.
nPlace a sleeve inside the leg stand aligning the sleeve ends with holes in the stand and fixed nut.
nSlide the entire combination into the holes and through the sleeve. Tighten securely.
nRepeat with the second wheel assembly.
14
