operation
to use OUTFEED SUPPORT
See Figure 38.
The outfeed support slides to give the operator additional support for cutting long workpieces.
With the table saw in the off position, stand behind the saw.
Grasp the outfeed support with both hands and pull it until it is fully extended.
to use the table extension
See Figure 39.
OUTFEED SUPPORT
The table extension provides the operator with additional table width for supporting wider workpieces.
To extend: |
| |
Set the rip fence to 16 in. |
| |
Push the table extension lever beneath the saw table | Fig. 38 | |
towards the back of the saw. |
| |
Grasp the table extension with both hands and pull it until | TABLE | |
the scale on the front rail indicates the desired measure- | ||
ment. | EXTENSION | |
LEVER | ||
Retighten the table extension lever by pulling it towards | ||
| ||
the front of the saw. |
| |
To close: |
| |
Push the table extension lever beneath the saw table |
| |
towards the back of the saw. |
|
Push the table extension with both hands back toward the saw table.
Retighten the table extension lever by pulling it towards the front of the saw.
LOWER
SCALE
Fig. 39
30
