Extron electronic RGB 192S, RGB 192V Installation and Operation, cont’d, Connections and Switches

Installation and Operation, cont’d

3.	Hold the interface with attached brackets against the
	underside of the desk/table. With a soft pencil mark the
	location of holes for screws on the desk based on the
	following:

For the RGB 190 and RGB 192, mark the opening approximately 1.0" x 5.7" ( 2.5 cm x 14.5 cm).

For the RGB 198, mark the opening approximately 1.75" x 13.0" (4.5 cm x 33.0 cm).

IODUA

PMOC

RETU

		GR		NOM
				ROTI
	1B
	29		-H
2	1	LEVELS	IHS
4 3	NO		STF
6 5		GORRE
OI.DNUOAM.PMOSNDD

Figure 2-2 — Through-desk mounting

4.	Cut out the material from the installation area with a
	jigsaw. Check the opening size by inserting the interface
	part way through the hole. If needed, use a saw, file or
	sandpaper to enlarge the hole. Smooth the edges of the
	hole with sandpaper.
5.	Drill pilot holes 1/4" (6.4 mm) deep, and 3/32" (2 mm)
	diameter in the underside or inside (concealed side) of the
	furniture where the interface will be located.
6.	Secure the interface to the desk with the provided wood
	screws.
7.	To adjust the height of the interface within the desk, slide
	the interface up or down to the desired position, then
	tighten the screws that attach the brackets to the interface.

Rack mounting (RGB 198 only)

1.	Remove rubber feet if they were previously installed on
	the bottom of the interface.
2.	Mount the interface on either side of an 19" 1U Universal
	Rack Shelf (part # 60-190-01) using two 4-40 x 3/16"
	screws to secure it to the shelf. See figure 2-3.

3.Install blank panel(s) or other unit(s) on the rack shelf.

4.Attach the rack shelf to the rack using the supplied bolts.

6" Deep Rack Shelf	1/4 Rack Width Front False
	Faceplate

Front false faceplate uses 2 screws.

RGB 198

Use 2 mounting holes.

(2) 4-40 x 3/16" Screws

Figure 2-3 — Rack mounting

Connections and Switches

Figures 2-4 and 2-5 show the front and rear panel of the

RGB 192 and the RGB 198, respectively. With the exception of audio features (numbers 2 and 9 ), all numbers for figure 2-4 pertain to both the RGB 190 and 192 models.

1Power indicator —

Amber — Indicates power is applied.

Green — Indicates that power is applied and a sync signal is present on the input.

1	2	3	4	5			6
		C O M P U T E R		H - S H I F T	S E R R					D D S P
	AUDIO				S O G					N O M O N .
					L E V E L					M . AU D I O
					ON
					1	2	3	4	5	6
		I N P U T	M O N I T O R	R G B 1 9 2
POWER								AUDIO
12-15V
1A MAX.

L/MONO R

7 8 9

Figure 2-4 — RGB 192 front and rear panel features

2-4 RGB 190F, RGB 192, and RGB 198 • Installation and Operation RGB 190F, RGB 192, and RGB 198 • Installation and Operation 2-5