3.Remove the terminal cover plate — Loosen (do not remove) the two screws in the keyhole slots on the top terminal cover plate and remove the cover plate as shown below.
Loosen, but do not remove the terminal cover plate screws in the two keyhole slots.
Terminal Cover Plate
Figure 2. Remove Terminal Cover Plate
4.Routing cables through the terminal cover plate — The plate is mounted to the speaker with the transformer side down.
a.When using flexible conduit — Insert the conduit into the cover plate opening using an appropriate conduit adapter, and secure the conduit to the plate. See below.
Flexible Conduit Adapter
Flexible Conduit
Terminal Cover Plate
Seismic Cable Pass
Through Loop
Rear of Speaker
Speaker |
Terminal |
Figure 3. Flexible Conduit Adapter
NOTE: Installation of conduit and conduit adapters should conform to all 
applicable building codes and local ordinances.
SF 228T Speaker System • Installation | 4 |
